Washing Machine Repair Near You
Washer repair near you starts with one call to 1-833-563-1092. Share your ZIP code and the problem, and your call is routed to an independent local washer repair pro. Fixr puts most washer repairs between $150 and $300. Help covers Whirlpool, GE, Samsung, LG and other major brands.
Free referral service. Have your ZIP code ready so your call reaches a provider near you.
Last updated October 2026
Washer repair key facts
Washer repair fixes problems that stop your washing machine from filling, agitating, spinning or draining. Common causes are a clogged drain pump, a broken lid switch or door lock, worn drive belts, a failed motor coupling or bad water inlet valve. A technician can test each part and replace the one that failed.
- Typical cost
- $150 – $300 (Fixr)
- Average life
- About 13 years (NAHB)
- Common parts
- drain pump, water inlet valve, lid switch, door lock assembly
- Urgent if
- water is leaking onto the floor
- Phone
- 1-833-563-1092
What are the signs my washer needs repair?
Small problems tend to get worse and more expensive the longer they wait. If you notice any of these, book a repair.
- Clothes come out soaking wet
- Error code on the display
- Loud banging during the spin cycle
- A burning or musty smell
- Water around the base after a wash
- The drum will not turn by hand
- The cycle stops halfway through
- The door stays locked after the cycle
What are the most common washer problems?
These are the faults technicians see most, and what usually causes them.
Washer will not drain
A clogged drain pump filter, a kinked drain hose, or a pump motor that has burned out.
Washer will not spin
Often a faulty lid switch or door lock, a worn drive belt, or a broken motor coupler.
Leaking water
Torn door boot seal on front loaders, a loose hose, or a cracked tub or pump housing.
Shaking and walking across the floor
Worn shock absorbers or suspension springs, or an unbalanced load.
Will not fill with water
A failed water inlet valve, kinked supply hoses, or a bad pressure switch.
Door will not unlock
A failed door lock assembly or water left in the drum after a drain problem.
Step-by-step troubleshooting: Washer Not Draining: Causes and What to Do
Need washer repair today?
Call 1-833-563-1092. Have your ZIP code ready.
How is a washer repaired?
- Diagnose. The technician will run a diagnostic cycle, read error codes and test the pump, valves, switches and motor.
- Quote. You get the price for parts and labor before any work starts.
- Repair. The failed part is replaced, often on the same visit if it is on the truck.
- Test. The washer is run to confirm the fix.
- Prevent. Ask what caused the failure and how to keep it from happening again.
How long does it take? Many washer repairs are finished in one visit when the part is on hand. Special-order parts add a return trip once the part arrives.
Washer parts and terms technicians use
Knowing these words helps you describe the problem and understand the quote.
How much does washer repair cost?
Fixr puts most washer repairs between $150 and $300, and Thumbtack reports an average of about $224. Expect a service call fee of about $50 to $100, which many providers apply to the repair.
Cost depends on the part that failed, the brand, labor time and whether a part must be ordered. Read the washing machine repair cost guide.
| Source | What they report |
|---|---|
| Fixr | $150 – $300 |
| Thumbtack | $137 – $364 (about $224 average) |
| HomeAdvisor | $50 – $450 |
| This Old House | $100 – $650 (washers and dryers combined) |
What should I do while I wait?
- Stop the cycle and turn off both water valves behind the washer.
- If water is on the floor, unplug the washer before you mop.
- Do not force a locked door. Wait for it to release or for the technician.
- If the drum is full, drain it slowly through the pump filter into a shallow pan.
- Write down any error code shown on the display.
Quick checks you can do safely
- Clean the drain pump filter, usually behind a small panel at the bottom front.
- Check that the drain hose is not kinked or pushed too far into the standpipe.
- Make sure both water taps behind the washer are fully open.
- Re-level the washer and split up heavy loads like comforters.
Can I fix my washer myself?
Some fixes are safe for homeowners. Others need training, tools or certification.
| Task | DIY? | Why |
|---|---|---|
| Clean the drain pump filter | Yes | Fixes many slow-drain problems. |
| Replace fill hoses | Maybe | Simple, but leaks are costly if fittings are loose. |
| Replace a lid switch or door lock | Pro | Needs cabinet access and wiring tests. |
| Motor, bearings or control board | Pro | Heavy parts, diagnosis and calibration needed. |
When should I call a washer repair pro?
- Water is leaking onto the floor
- The door is locked with water inside
- You smell burning during the cycle
- The washer trips the breaker
- Quick checks did not fix the problem
What happens when I call?
- You call 1-833-563-1092. There is no charge for the referral.
- You give your ZIP code, the brand and the problem.
- Your call is routed to an independent provider who serves your area.
- The provider explains their fees and sets a visit.
- After a diagnosis, you approve the price before work starts.
Is it worth repairing my washer?
NAHB data puts the average life at about 13 years. A common rule of thumb: repair if the washer is under half its expected life and the repair costs less than half the price of a new one.
Work through the repair-or-replace guide.
Washer repair questions
Is it worth fixing a washing machine?
NAHB data puts the average washer life at about 13 years. If yours is younger than that and the repair is a pump, switch, valve or belt, fixing it usually costs far less than replacing it.
Why does my front load washer smell?
Moisture trapped in the door boot and drain filter grows mildew. Wipe the seal, clean the filter and run a hot cleaning cycle. If the smell stays, the drain may be partly blocked.
What does my washer error code mean?
Error codes point to the part of the machine that failed, like the drain, door lock or water supply. Tell the technician the code when you call so they can bring the right parts.
Can a washer that will not spin be fixed?
Yes, nearly always. Spin problems are usually caused by a lid switch, door lock, belt or motor coupler, all of which are common, low-cost parts.
Do technicians work on high-efficiency washers?
Yes. Technicians in our network repair HE top loaders, front loaders, stackable units and all-in-one washer dryer combos.
How do I get water out of a washer that will not drain?
Turn it off, place towels and a shallow pan under the drain filter door, and open the filter slowly to let water out. Then clean any debris you find.
Related appliance repairs
Get your washer working again
Call 1-833-563-1092 with your ZIP code to speak with a local washer repair pro.
1-833-563-1092Free referral service. Have your ZIP code ready.